was successfully added to your cart.

Bristol Finish Water Based Interior Marine Coatings – Application on a Previously Varnished Surface

By January 18, 2016 Boat Varnishing Tips

If the original varnished surface is intact without discolouration or signs of severe deterioration, use an industrial detergent to ensure the surface is free of moisture, oil & other contaminants before sanding. Sand the existing varnished surface to a 240 grit profile, when dry sanded. Ensuring the wood surface is free of dust, blow down with clean, dry, filtered air & wash with a Surface Prep solution using the two-cloth method (one wet, one dry). Clean, non-drycleaned rags should be used, or commercial cleaning cloths such as 3M Automotive Wipes, which are lint free. Full removal of the existing coating to bare timber will be necessary if the original varnished surface is breaking down, or the varnish and/or timber is discoloured or damaged. If this is required, refer to above “Bare Wood” application steps.

  1. To a clean, dry surface, apply a minimum 6-7 coats of Bristol Finish Classic Clear Water Based Interior High Gloss Urethane. More coats may be required for porous & problematic timbers, such as mahogany. Allow a minimum of 1 hour, but no longer than 4 hours between coats. No sanding is required if overcoating occurs within this time period. If this time is exceeded, sand to a 240 grit profile, when dry sanded. Wash with a Surface Prep solution using the two-cloth method (one wet, one dry), before the next coat application.
  2. Before application of the final finishing coat, allow a minimum of 4 hours from the previous coat, then sand the surface to a 240 grit profile, when dry sanded. Wash with a Surface Prep solution using the two-cloth method (one wet, one dry). Use tack cloths prior to painting. Apply 1-2 final coats